Protectosil WS 700 P

Is paste-like impregnation based on silane chemistry for the hydrophobation of dense building materials especially alkaline substrates such as concrete.

Protectosil WS 700 P

Protectosil® WS 700 P is used undiluted. The exact amount of Protectosil® WS 700 P to be applied is highly depending on the absorbance and humidity of the substrate. Do not apply too much product since material could get lost by run-offs or shiny or speckled surfaces could result. To determine the exact amount to be applied it is recommended to do a small test patch first. The substrates to be treated should be dry and clean. Acceptable surface cleaning methods include sandblasting and water blasting. It has to be ensured that the substrate has not just dried out in the areas close to the surface. After direct exposure to water or saturation of the capillaries an adequate drying time has to be provided. The application of Protectosil® WS 700 P in direct, intensive sunlight may result in increased run-offs. Damages such as cracks >0,3 mm or delaminations have to be repaired.

 

Technical Information

Is suited for the hydrophobizing impregnation of porous, mineral substrates
Shows very high reactivity and resistance against alkali
Shows optimum penetration even in dense mineral substrates
Shows no formation of sticky silicone films
Gives invisible and water vapor permeable protection
Reduces significantly the uptake of water
Reduces the uptake of water soluble pollutants
Protects hair like cracks of up to 0,3 mm
Is applied undiluted
Has a long contact time with the substrate due to its paste-like consistency thus allowing for very high penetration depth, reducing loss of material by run-offs, and facilitating overhead applications


Buy online

Protectosil 008 - £68.56 per Kg

Packed in 25 Kg Plastic jerry cans

Quantity: