Protectosil WS 600

Aqueous emulsion for the water repellent treatment of mineral porous materials, especially facades. Essentially VOC free.

Protectosil WS 600

Protectosil® WS 600 should be applied by wet-on-wet flow coating to the saturation point. The solution should be applied in 2 - 3 coats without drying between the coats. On vertical surfaces the solution should run down in the form of a clearly visible descending wet curtain. This is achieved by allowing the solution to flow against the surface of the building material without pressure. Most liquid delivery devices e.g. airless pumping equipment are suitable. The material should not be atomized or applied with a brush. The water repellent effect of Protectosil® WS 600 can develop within minutes or require up to several days depending on the substrate and weather conditions. Therefore, the impregnation should be applied continuously and without a break to avoid overlapping.

 

Technical Information

Is suited for the water repellent impregnation of porous mineral substrates
Does not form sticky silicone films
Shows very good penetration on absorbent mineral materials
Gives water vapor permeable, colorless protection
Reduces significantly the uptake of water
Repels water soluble pollutants
Effective on micro cracks of up to 0.3 mm
Can be diluted with water
Is very efficient on mineral rendering, sand-lime brickwork, hard-baked brickwork, roofing tiles


Buy online

Protectosil 008 - £68.56 per Kg

Packed in 25 Kg Plastic jerry cans

Quantity: